肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。     

间接蒸发冷却新风机组净化室内PM2.5特性

为有效降低室内PM2.5,指导间接蒸发冷却新风机组的设计选型,推导了新风机组净化效力和净化能效评价指标的数学表达式,并利用自行研制的间接蒸发冷却新风机组,分析了2种过滤器在不同运行工况下净化PM2.5的特性。结果表明,MERV 7+16和MERV 7+13的计数效率均随颗粒物粒径增加而提高,且前者的计数效率高于后者;由于滤材的不同,MERV 7+16的初阻力更小。MERV 7+16的渗透系数更小,其净化效力也要大于MERV 7+13;由于PM10在室内的自然沉降作用更显著,过滤器对PM10的净化效力明显大于PM2.5和PM1。将室内新风负荷作为新风机组能耗的一部分,在对比天津和南宁地区新风机组的净化能效时发现,由于两地区冬季室外温度存在明显差异,导致处于天津地区的新风机组若要在冬季获得同等的洁净空气量,需付出更多的能耗代价。     

江苏省太湖流域水生态健康评估的初步实践及展望

阐述了水生态健康的内涵与意义,从江苏省率先在太湖流域开展水生态环境功能分区管理的顶层设计,构建以水生态健康指标为核心的水生态健康评估技术体系,地方对照水生态环境功能区划的水生态分级管控目标开展的应用与实践结果等3个方面,回顾了江苏省太湖流域水生态健康评估工作的主要进展,提出了完善水生态健康评估技术体系和推进流域水生态健康评估工作的建议。     

Usability of non-standard lower anchor configurations for child restraint system (CRS) installation

Abstract

Objectives: The objective of this study was to determine whether the amount of tension required for proper child restraint system (CRS) installation varies with lower anchor spacing and to determine whether nonexperts can produce adequate tension on wider-than-standard lower anchor configurations.

Methods: CRSs were installed by certified child passenger safety technicians (CPSTs; n?=?6 subjects, n?=?72 installations) and nonexperts (n?=?30 subjects, n?=?120 installations) on a mock-up vehicle seat fixture with lower anchors set at 11 (standard), 15, 19, and 23 in. apart from one another. Each CPST installed a rear-facing (RF) infant base, RF convertible, and forward-facing (FF) convertible into each of the 4 spacing configurations in random order. The CPSTs were instructed to tighten the lower connector strap until the tension was exactly at the threshold between passing and failing the 1-in. test. Each nonexpert installed one CRS model into all 4 spacing conditions in random order. Nonexperts were instructed to install the CRS to the best of their ability. The tension produced on the lower connector strap was recorded via load cell in the lower anchor assembly of the vehicle seat. Resultant tension magnitudes were compared across spacing conditions using matched pair t-tests. The CPSTs’ mean 1-in. test threshold values were compared to tensions produced by nonexperts. Installations were visually evaluated for errors and qualitative usability feedback was collected via survey.

Results: CPSTs installed the infant base with higher tensions in the 15-, 19-, and 23-in. configurations compared to the standard 11-in. configuration (P = .034, .032, and .003, respectively). The nonexperts installed the infant base with higher tension in the 15- and 23-in. configurations compared to the 11-in. configuration (P = .004 and .026, respectively). The RF convertible and FF convertible installations showed no significant differences in tension among any of the spacing configurations for either group. Only 19% of the nonexperts’ installations were tight enough to pass CPST thresholds, and the pass rate did not vary with respect to lower anchor spacing. In feedback surveys, the nonexpert group did not show a consistent preference for either standard or wider-than-standard lower anchor configurations.

Conclusions: The amount of tension required to pass the 1-in. rule did not vary with lower anchor spacing configurations for the RF and FF convertible CRS, but the infant base required more tension in wider anchor configurations. Nonexperts tended to produce less than ideal tension in all configurations, although their tension magnitudes increased for the infant base in wider configurations.     

《环境监测 分析方法标准制修订技术导则》(HJ 168—2010)对土壤环境监测标准制修订适用性探讨

针对土壤环境监测的复杂性和特殊性,从空白试验、检出限、方法验证、质量控制和标准文本等方面,指出了《环境监测分析方法标准制修订技术导则》《HJ 168—2010》对土壤环境监测标准制修订工作的适用性和执行中存在的问题。提出,为保证土壤标准制修订质量和标准执行质量,应研究适宜土壤监测方法标准的质量控制指标体系和评价体系,及时修订《HJ 168—2010》或发布补充要求;对现有土壤监测方法标准进行技术评估,加强对于土壤标准制修订工作的指导和监管。     

Carbon trading thickness and market efficiency in a socialist market economy

Unlike the European Union emission trade system (EU ETS), China’s pilot ETSs implemented diversified policy designs instead of using a uniform framework. Variance ratio test is used to evaluate the Efficient Market Hypothesis (EMH) in China’s carbon trading markets. The results of two versions of variance ratio tests indicate that the carbon trading market in Hubei is considered weak form efficient, and the socialist market economy does not necessarily lead to market inefficiency in carbon trading markets. Thin trading activities generate market frictions and bias the Efficient Market Hypothesis (EMH) tests.     

重大基坑坍塌事故虚拟仿真系统研究

为预防基坑坍塌事故发生、进行重大事故警示教育，以杭州地铁湘湖站北2基坑坍塌事故为素材，研究构建重大基坑坍塌事故虚拟仿真培训系统。对案例事故涉及的设计、施工、环境三大因素的技术问题进行总结，研究了事故链各致险因素及对推动事故发生所起作用，完成仿真系统平台设计和开发工作。系统应用多种制作技术创建工程场景模型，展示深基坑工程复杂的施工工序和空间关系，再现基坑坍塌事故发生发展过程和贴近实际的灾难场景。研究结果表明:仿真系统成果可丰富地下工程教学、施工现场安全教育和安全监察培训的内容和形式。     

On the search for mimetic patterns in environmental disclosure: an international perspective

In this paper, we assert and test the proposition that environmental disclosure (ED) is structured by institutionalised myths and that is why ED is decoupled from environmental performance and media pressures. Focusing on firms from Canada, France and Germany, findings show that ED mimetic isomorphism for different topics varies among countries and by industry sensitiveness to the environment. The results corroborate the institutional presumption that institutionalised myths vary among different contexts. Our findings also suggest that institutionalised ED structures may not reflect environmental performance, mimetic patterns being affected by environmental performance. However, the decoupling between ED mimetic isomorphism and environmental performance decrease when firms’ ED credibility is questioned by the media.     

浅谈县级环境监测质量管理工作现状及对策

当前环保系统垂直改革稳步推进,县级环境监测质量管理工作也迎来新的机遇与挑战。从县级环境监测站质量管理工作现状着手,分析新形势下存在质量管理体系有效性缺乏、现场监测过程质量管理薄弱、质量管理意识尚待提高等问题。提出,应从加强体系建设、提高现场监测水平、强化考核培训力度等方面改进县级环境监测质量管理工作水平。     

Double Green Process: a low environmental impact method for recycling of CdTe,a-Si and CIS/CIGS thin-film photovoltaic modules

On the basis of the method for managing the end of life of CdTe photovoltaic panels previously proposed by the authors, a new method for the recycling of all types of thin-film panels (CdTe, a-Si and CIS/CIGS) has been developed and optimised under a research project founded by Enel Foundation and CRUI Foundation. The DGP process has been developed through a feasibility study carried out from three points of view: technical, environmental and economic. The process is composed by two sub-processes matched to each other, one suitable for CdTe panels (named DGPa) and the other one for a-Si and CIS/CIGS panels (DGPb). The Double Green Panel process is based mainly on mechanical treatments with a minimum use of chemicals and it is characterised by a greater level of automation and a high flexibility in production capacity. The potential environmental impacts of various configurations of the DGP process have been extensively analysed with LCA tool in order to develop an environmentally friendly process. The economic feasibility has been assessed through the Discounted Cash Flow Analysis (DCFA) method. The revenues associated to the recovery of valuable and common materials and the recycling costs have been taken into account.